Terms used in this subpart are defined in the Clean Air Act, in Sec. 63.2, and in this section as follows:
Bag leak detection system means a system that is capable of continuously monitoring relative particulate matter (dust) loadings in the exhaust of a baghouse in order to detect bag leaks and other upset conditions. A bag leak detection system includes, but is not limited to, an instrument that operates on triboelectric, light scattering, transmittance or other effect to continuously monitor relative particulate matter loadings.
Baghouse means a control device that collects particulate matter by filtering the gas stream through bags. A baghouse is also referred to as a ``fabric filter.''
Batch copper converter means a Pierce-Smith converter or Hoboken converter in which copper matte is oxidized to form blister copper by a process that is performed in discrete batches using a sequence of charging, blowing, skimming, and pouring.
Blowing means the operating mode for a batch copper converter during which air or oxygen-enriched air is injected into the molten converter bath.
Capture system means the collection of components used to capture gases and fumes released from one or more emission points, and to convey the captured gases and fumes to a control device. A capture system may include, but is not limited to, the following components as applicable to a given capture system design: duct intake devices, hoods, enclosures, ductwork, dampers, manifolds, plenums, and fans.
Charging means the operating mode for a batch copper converter during which molten or solid material is added into the vessel.
Control device means the air pollution control equipment used to collect particulate matter emissions. Examples of such equipment include, but are not limited to, a baghouse, an electrostatic precipitator, and a wet scrubber.
Copper concentrate dryer means a vessel in which copper concentrates are heated in the presence of air to reduce the moisture content of the material. Supplemental copper-bearing feed materials and fluxes may be added or mixed with the copper concentrates fed to a copper concentrate dryer.
Copper converter department means the area at a primary copper smelter in which the copper converters are located.
Copper matte means a material predominately composed of copper and iron sulfides produced by smelting copper ore concentrates.
Deviation means any instance in which an affected source subject to this subpart or an owner or operator of such a source fails to meet any of the following:
(1) Any requirement or obligation established by this subpart including, but not limited to, any emission limitation (including any operating limit) or work practice standard;
(2) Any term or condition that is adopted to implement an applicable requirement in this subpart and that is included in the operating permit for any affected source required to obtain such a permit; or
(3) Any emission limitation (including any operating limit) or work practice standard in this subpart during startup, shutdown, or malfunction, regardless whether or not such failure is permitted by this subpart.
Emission limitation means any emission limit, opacity limit, operating limit, or visible emission limit.
Fugitive dust material means copper concentrate, dross, reverts, slag, speiss, or other solid copper-bearing materials.
Fugitive dust source means a stationary source of particulate matter emissions resulting from the handling, storage, transfer, or other management of fugitive dust materials where the source is not associated with a specific process, process vent, or stack. Examples of a fugitive dust source include, but are not limited to, on-site roadways used by trucks transporting copper concentrate, unloading of materials from trucks or railcars, outdoor material storage piles, and transfer of material to hoppers and bins.
Holding means the operating mode for a batch copper converter during which the molten bath is maintained in the vessel but no blowing is performed nor is material added into or removed from the vessel.
Opacity means the degree to which emissions reduce the transmission of light.
Particulate matter means any finely divided solid or liquid material, other than uncombined water, as measured by the specific reference method.
Pouring means the operating mode for a batch copper converter during which molten copper is removed from the vessel.
Primary copper smelter means any installation or any intermediate process engaged in the production of copper from copper sulfide ore concentrates through the use of pyrometallurgical techniques.
Responsible official means responsible official as defined in 40 CFR 70.2.
Skimming means the batch copper converter operating mode during which molten slag is removed from the vessel.
Slag cleaning vessel means a vessel that receives molten copper-bearing material and the predominant use of the vessel is to separate this material into molten copper matte and slag layers.
Smelting furnace means a furnace, reactor, or other type of vessel in which copper ore concentrate and fluxes are melted to form a molten mass of material containing copper matte and slag. Other copper-bearing materials may also be charged to the smelting furnace.
Work practice standard means any design, equipment, work practice, or operational standard, or combination thereof, that is promulgated pursuant to section 112(h) of the Clean Air Act.
Sec. Table 1 to Subpart QQQ of Part 63--Applicability of General
Provisions to Subpart QQQ
As required in Sec. 63.1457, you must comply with the requirements of the NESHAP General Provisions (40 CFR part 63, subpart A) shown in the following table: ----------------------------------------------------------------------------------------------------------------
Citation Subject Applies to subpart QQQ Explanation----------------------------------------------------------------------------------------------------------------Sec. 63.1.......................... Applicability.......... Yes....................Sec. 63.2.......................... Definitions............ Yes....................Sec. 63.3.......................... Units and Abbreviations Yes....................Sec. 63.4.......................... Prohibited Activities.. Yes....................Sec. 63.5.......................... Construction and Yes....................
Reconstruction.Sec. 63.6(a)-(g)................... Compliance with Yes....................
Standards and
Maintenance
requirements.Sec. 63.6(h)....................... Determining compliance No..................... Subpart QQQ specifies
with Opacity and VE the requirements and
standards. test protocol used to
determine compliance
with the opacity
limits.Sec. 63.6(i)-(j)................... Extension of Compliance Yes....................
and Presidential
Compliance Exemption.Sec. 63.7(a)(1)-(2)................ Applicability and No..................... Subpart QQQ specifies
Performance Test Dates. performance test
applicability and
dates.Sec. 63.7(a)(3), (b)-(h)........... Performance Testing Yes....................
Requirements.Sec. 63.8 except for (a)(4),(c)(4), Monitoring Requirements Yes....................
and (f)(6).Sec. 63.8(a)(4).................... Additional Monitoring No..................... Subpart QQ does not
Requirements for require flares.
Control devices in
Sec. 63.11.Sec. 63.8(c)(4).................... Continuous Monitoring No..................... Subpart QQQ specifies
System Requirements. requirements for
operation of CMS.Sec. 63.8(f)(6).................... RATA Alternative....... No..................... Subpart QQQ does not
require continuous
emission monitoring
systems.Sec. 63.9.......................... Notification Yes....................
Requirements.
Sec. 63.9(g)(5).................... DATA reduction......... No..................... Subpart QQQ specifies
data reduction
requirementsSec. 63.10 except for (b)(2)(xiii) Recordkeeping and Yes....................
and (c)(7)-(8). reporting Requirements.Sec. 63.10(b)(2)(xiii)............. CMS Records for RATA No..................... Subpart QQQ does not
Alternative. require continuous
emission monitoring
systems.Sec. 63.10(c)(7)-(8)............... Records of Excess No..................... Subpart QQQ specifies
Emissions and record keeping
Parameter Monitoring requirements
Accedences for CMS.Sec. 63.11......................... Control Device No..................... Subpart QQQ does not
Requirements. require flaresSec. 63.12......................... State Authority and Yes....................
Delegations.Sec. Sec. 63.13-63.15............. Addresses, Yes....................
Incorporation by
Reference,
Availability of
Information.----------------------------------------------------------------------------------------------------------------
Sec. Figure 1 to Subpart QQQ of Part 63--Data Summary Sheet for
Determination of Average Opacity ----------------------------------------------------------------------------------------------------------------
Average
Visible opacity for 1-
emissions minute
Average interference interval
Number of Converter aisle opacity for 1- observed blowing
Clock time converters activity minute during 1- without
blowing interval minute visible
(percent) interval? emission
(yes or no) interferences
(percent)----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------------------------------- Subpart RRR_National Emission Standards for Hazardous Air Pollutants for
Secondary Aluminum Production
Source: 65 FR 15710, Mar. 23, 2000, unless otherwise noted.
General