(a) Notifications. (1) The owner or operator of any affected source or process unit must submit the applicable notifications from subpart A of this part, as specified in Table 1 of this subpart.
(1) The owner or operator of any affected source or process unit must submit the applicable notifications from subpart A of this part, as specified in Table 1 of this subpart.
(2) Notifications specific to Georgia-Pacific Corporation's affected sources in Big Island, Virginia.
(i) For a compliance extension under Sec. 63.863(c)(1), submit a notice that provides the date of Georgia-Pacific's determination that the black liquor gasification system is not successful and the reasons why the technology is not successful. The notice must be submitted within 15 days of Georgia-Pacific's determination, but not later than March 16, 2005.
(ii) For operation under Sec. 63.863(c)(2), submit a notice providing: a statement that Georgia-Pacific Corporation intends to run the Kraft black liquor trials, the anticipated period in which the trials will take place, and a statement explaining why the trials could not be conducted prior to March 1, 2005. The notice must be submitted at least 30 days prior to the start of the Kraft liquor trials.
(3) In addition to the requirements in subpart A of this part, the owner or operator of the hog fuel dryer at Weyerhaeuser Paper Company's Cosmopolis, Washington, facility (Emission Unit no. HD-14) must include analysis and supporting documentation demonstrating conformance with EPA guidance and specifications for bag leak detection systems in Sec. 63.864(e)(12) in the Notification of Compliance Status.
(b) Additional reporting requirements for HAP metals standards. (1) Any owner or operator of a group of process units in a chemical recovery system at a mill complying with the PM emissions limits in Sec. 63.862(a)(1)(ii) must submit the PM emissions limits determined in Sec. 63.865(a) for each affected kraft or soda recovery furnace, smelt dissolving tank, and lime kiln to the Administrator for approval. The emissions limits must be submitted as part of the notification of compliance status required under subpart A of this part.
(1) Any owner or operator of a group of process units in a chemical recovery system at a mill complying with the PM emissions limits in Sec. 63.862(a)(1)(ii) must submit the PM emissions limits determined in Sec. 63.865(a) for each affected kraft or soda recovery furnace, smelt dissolving tank, and lime kiln to the Administrator for approval. The emissions limits must be submitted as part of the notification of compliance status required under subpart A of this part.
(2) Any owner or operator of a group of process units in a chemical recovery system at a mill complying with the PM emissions limits in Sec. 63.862(a)(1)(ii) must submit the calculations and supporting documentation used in Sec. 63.865(a)(1) and (2) to the Administrator as part of the notification of compliance status required under subpart A of this part.
(3) After the Administrator has approved the emissions limits for any process unit, the owner or operator of a process unit must notify the Administrator before any of the actions in paragraphs (b)(3)(i) through (iv) of this section are taken:
(i) The air pollution control system for any process unit is modified or replaced;
(ii) Any kraft or soda recovery furnace, smelt dissolving tank, or lime kiln in a chemical recovery system at a kraft or soda pulp mill complying with the PM emissions limits in Sec. 63.862(a)(1)(ii) is shut down for more than 60 consecutive days;
(iii) A continuous monitoring parameter or the value or range of values of a continuous monitoring parameter for any process unit is changed; or
(iv) The black liquor solids firing rate for any kraft or soda recovery furnace during any 24-hour averaging period is increased by more than 10 percent above the level measured during the most recent performance test.
(4) An owner or operator of a group of process units in a chemical recovery system at a mill complying with the PM emissions limits in Sec. 63.862(a)(1)(ii) and seeking to perform the actions in paragraph (b)(3)(i) or (ii) of this section must recalculate the overall PM emissions limit for the group of process units and resubmit the documentation required in paragraph (b)(2) of this section to the Administrator. All modified PM emissions limits are subject to approval by the Administrator.
(c) Excess emissions report. The owner or operator must report quarterly if measured parameters meet any of the conditions specified in paragraph (k)(1) or (2) of Sec. 63.864. This report must contain the information specified in Sec. 63.10(c) of this part as well as the number and duration of occurrences when the source met or exceeded the conditions in Sec. 63.864(k)(1), and the number and duration of occurrences when the source met or exceeded the conditions in Sec. 63.864(k)(2). Reporting excess emissions below the violation thresholds of Sec. 63.864(k) does not constitute a violation of the applicable standard.
(1) When no exceedances of parameters have occurred, the owner or operator must submit a semiannual report stating that no excess emissions occurred during the reporting period.
(2) The owner or operator of an affected source or process unit subject to the requirements of this subpart and subpart S of this part may combine excess emissions and/or summary reports for the mill. [66 FR 3193, Jan. 12, 2001 as amended at 66 FR 16408, Mar. 26, 2001; 68 FR 7718, Feb. 18, 2003; 68 FR 42605, July 18, 2003; 68 FR 46108, Aug. 5, 2003; 69 FR 25323, May 6, 2004]