(a) Incorporation by reference. The documents in paragraph (b) of this section have been incorporated by reference. The incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be inspected at U.S. EPA, OAR, Air and Radiation Docket and Information Center, 401 M St., SW., Washington, DC 20460, or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.
(b) The following paragraphs and tables set forth the material that has been incorporated by reference in this part.
(1) ASTM material. The following table sets forth material from the American Society for Testing and Materials which has been incorporated by reference. The first column lists the number and name of the material. The second column lists the section(s) of this part, other than Sec. 91.6, in which the matter is referenced. The second column is presented for information only and may not be all inclusive. Copies of these materials may be obtained from American Society for Testing and Materials, 1916 Race St., Philadelphia, PA 19103. ------------------------------------------------------------------------
Document number and name 40 CFR part 91 reference------------------------------------------------------------------------ASTM D86-93:
Standard Test Method for Appendix A to Subpart D.
Distillation of
Petroleum Products.
ASTM D323-90:
Standard Test Method for Appendix A to Subpart D.
Vapor Pressure of
Petroleum Products (Reid
Method).ASTM D1319-93:
Standard Test Method for Appendix A to Subpart D.
Hydrocarbon Types in
Liquid Petroleum
Products by Fluorescent
Indicator Adsorption.ASTM D2622-92:
Standard Test Method for Appendix A to Subpart D.
Sulfur in Petroleum
Products by X-Ray
Spectrometry.ASTM D2699-92:
Standard Test Method for Appendix A to Subpart D.
Knock Characteristics of
Motor Fuels by the
Research Method.ASTM D2700-92:
Standard Test Method for Appendix A to Subpart D.
Knock Characteristics of
Motor and Aviation Fuels
by the Motor Method.ASTM D3231-89:
Standard Test Method for Appendix A to Subpart D.
Phosphorus in Gasoline.ASTM D3606-92:
Standard Test Method for Appendix A to Subpart D.
Determination of Benzene
and Toluene in Finished
Motor and Aviation
Gasoline by Gas
Chromatography.ASTM E29-93a:
Standard Practice for 91.207; 91.120; 91.509; 91.1307.
Using Significant Digits
in Test Data to
Determine Conformance
with Specifications.------------------------------------------------------------------------
(2) SAE material. The following table sets forth material from the Society of Automotive Engineers which has been incorporated by reference. The first column lists the number and name of the material. The second column lists the section(s) of this part, other than Sec. 91.7, in which the matter is referenced. The second column is presented for information only and may not be all inclusive. Copies of these materials may be obtained from Society of Automotive Engineers International, 400 Commonwealth Dr., Warrendale, PA 15096-0001. ------------------------------------------------------------------------
Document number and name 40 CFR part 91 reference------------------------------------------------------------------------SAE J1228/ISO 8665 November 91.104, 91.115; 91.118; 91.207; 91.1307.
1991 Small Craft-Marine
Propulsion Engine and
Systems-Power Measurements
and Declarations.SAE J1930 June 1993 91.113.
Electrical/Electronic
Systems Diagnostic Terms,
Definitions, Abbreviations
and Acronyms.SAE Paper 770141 Optimization 91.316
of a Flame Ionization
Detector for Determination
of Hydrocarbon in Diluted
Automotive Exhausts, Glenn
D. Reschke, 1977.------------------------------------------------------------------------