You must calculate and report the annual process CO2 emissions from all lime kilns combined using the procedure in paragraphs (a) and (b) of this section.
(a) If all lime kilns meet the conditions specified in Sec. 98.33(b)(4)(ii) or (iii), you must calculate and report under this subpart the combined process and combustion CO2 emissions from all lime kilns by operating and maintaining a CEMS to measure CO2 emissions according to the Tier 4 Calculation Methodology specified in Sec. 98.33(a)(4) and all associated requirements for Tier 4 in subpart C of this part (General Stationary Fuel Combustion Sources).
(b) If CEMS are not required to be used to determine CO2 emissions from all lime kilns under paragraph (a) of this section, then you must calculate and report the process and combustion CO2 emissions from the lime kilns by using the procedures in either paragraph (b)(1) or (b)(2) of this section.
(1) Calculate and report under this subpart the combined process and combustion CO2 emissions from all lime kilns by operating and maintaining a CEMS to measure CO2 emissions from all lime kilns according to the Tier 4 Calculation Methodology specified in Sec. 98.33(a)(4) and all associated requirements for Tier 4 in subpart C of this part (General Stationary Fuel Combustion Sources).
(2) Calculate and report process and combustion CO2 emissions from all lime kilns separately using the procedures specified in paragraphs (b)(2)(i) through (v) of this section.
(i) You must calculate a monthly emission factor for each type of lime produced using Equation S-1 of this section. Calcium oxide and magnesium oxide content must be analyzed monthly for each lime product type that is produced:[GRAPHIC] [TIFF OMITTED] TR30OC09.073 Where: EFLIME,i,n = Emission factor for lime type i, for month n
(metric tons CO2/ton lime).SRCaO = Stoichiometric ratio of CO2 and CaO for
calcium carbonate [see Table S-1 of this subpart] (metric tons
CO2/metric tons CaO).SRMgO = Stoichiometric ratio of CO2 and MgO for
magnesium carbonate (See Table S-1 of this subpart) (metric
tons CO2/metric tons MgO).CaOi,n = Calcium oxide content for lime type i, for month n,
determined according to Sec. 98.194(c) (metric tons CaO/
metric ton lime).MgOi,n = Magnesium oxide content for lime type i, for month
n, determined according to Sec. 98.194(c) (metric tons MgO/
metric ton lime).2000/2205 = Conversion factor for tons to metric tons.
(ii) You must calculate a monthly emission factor for each type of calcined byproduct or waste sold (including lime kiln dust) using Equation S-2 of this section:[GRAPHIC] [TIFF OMITTED] TR30OC09.074 Where: EFLKD,i,n = Emission factor for calcined lime byproduct/waste
type i sold, for month n (metric tons CO2/ton lime
byproduct).SRCaO = Stoichiometric ratio of CO2 and CaO for
calcium carbonate (see Table S-1 of this subpart((metric tons
CO2/metric tons CaO).SRMgO = Stoichiometric ratio of CO2 and MgO for
magnesium carbonate (See Table S-1 of this subpart) (metric
tons CO2/metric tons MgO).CaOLKD,i,n = Calcium oxide content for calcined lime
byproduct/waste type i sold, for month n (metric tons CaO/
metric ton lime).MgOLKD,i,n = Magnesium oxide content for calcined lime
byproduct/waste type i sold, for month n (metric tons MgO/
metric ton lime).2000/2205 = Conversion factor for tons to metric tons.
(iii) You must calculate the annual CO2 emissions from each type of calcined byproduct or waste that is not sold (including lime kiln dust and scrubber sludge) using Equation S-3 of this section:[GRAPHIC] [TIFF OMITTED] TR30OC09.075 Where: Ewaste,i = Annual CO2 emissions for calcined lime
byproduct or waste type i that is not sold (metric tons
CO2).SRCaO = Stoichiometric ratio of CO2 and CaO for
calcium carbonate (see Table S-1 of this subpart) (metric tons
CO2/metric tons CaO).SRMgO = Stoichiometric ratio of CO2 and MgO for
magnesium carbonate (See Table S-1 of this subpart) (metric
tons CO2/metric tons MgO).CaOwaste,i = Calcium oxide content for calcined lime
byproduct or waste type i that is not sold (metric tons CaO/
metric ton lime).MgOwaste,i = Magnesium oxide content for calcined lime
byproduct or waste type i that is not sold (metric tons MgO/
metric ton lime).Mwaste,i = Annual weight or mass of calcined byproducts or
wastes for lime type i that is not sold (tons).2000/2205 = Conversion factor for tons to metric tons.
(iv) You must calculate annual CO2 process emissions for all lime kilns using Equation S-4 of this section:[GRAPHIC] [TIFF OMITTED] TR30OC09.076 Where: ECO2 = Annual CO2 process emissions from lime
production from all lime kilns (metric tons/year).EFLIME,i,n = Emission factor for lime type i produced, in
calendar month n (metric tons CO2/ton lime) from
Equation S-1 of this section.MLIME,i,n = Weight or mass of lime type i produced in
calendar month n (tons).EFLKD,i,n = Emission factor of calcined byproducts or wastes
sold for lime type i in calendar month n, (metric tons
CO2/ton byproduct or waste) from Equation S-2 of
this section.MLKD,i,n = Monthly weight or mass of calcined byproducts or
waste sold (such as lime kiln dust, LKD) for lime type i in
calendar month n (tons).Ewaste,i = Annual CO2 emissions for calcined lime
byproduct or waste type i that is not sold (metric tons
CO2) from Equation S-3 of this section.t = Number of lime types producedb = Number of calcined byproducts or wastes that are sold.z = Number of calcined byproducts or wastes that are not sold.
(v) Calculate and report under subpart C of this part (General Stationary Fuel Combustion Sources) the combustion CO2 emissions from each lime kiln according to the applicable requirements in subpart C. [74 FR 56374, Oct. 30, 2009, as amended at 75 FR 66464, Oct. 28, 2010; 78 FR 71958, Nov. 29, 2013]