(a) Layout. All energy labels for refrigerators, refrigerator-freezers, freezers, dishwashers, clothes washers, water heaters, pool heaters, and room air conditioners shall use one size, similar colors, and typefaces with consistent positioning of headline, copy, and charts to maintain uniformity for immediate consumer recognition and readability. Trim size dimensions for all labels shall be as follows: width must be between 5\1/4\ inches and 5\1/2\ inches (13.34 cm. and 13.97 cm.); length must be between 7\3/8\ inches (18.78 cm.) and 7\5/8\ (19.34 cm.). Copy is to be set between 27 picas and 29 picas and copy page should be centered (right to left and top to bottom). Depth is variable but should follow closely the prototype labels appearing at the end of this part illustrating the basis layout. All positioning, spacing, type sizes, and line widths should be similar to and consistent with the prototype and sample labels in appendix L.
(b) Type style and setting. The Arial series typeface or equivalent shall be used exclusively on the label. Specific sizes and faces to be used are indicated on the prototype labels. No hyphenation should be used in setting headline or copy text. Positioning and spacing should follow the prototypes closely. Generally, text must be set flush left with two points leading except where otherwise indicated. See the prototype labels for specific directions.
(c) Colors. The basic colors of all labels covered by this section shall be process yellow or equivalent and process black. The label shall be printed full bleed process yellow. All type and graphics shall be print process black.
(d) Label types. The labels must be affixed to the product in the form of an adhesive label or a hang tag as follows:
(1) Adhesive labels. All adhesive labels should be applied so they can be easily removed without the use of tools or liquids, other than water, but should be applied with an adhesive with an adhesion capacity sufficient to prevent their dislodgment during normal handling throughout the chain of distribution to the retailer or consumer. The paper stock for pressure-sensitive or other adhesive labels shall have a basic weight of not less than 58 pounds per 500 sheets (25``x38'') or equivalent, exclusive of the release liner and adhesive. A minimum peel adhesion capacity for the adhesive of 12 ounces per square inch is suggested, but not required if the adhesive can otherwise meet the above standard.
(2) Hang tags. Labels may be affixed to the product in the form of a hang tag using string or similar material. The paper stock for hang tags shall have a basic weight of not less than 110 pounds per 500 sheets (25\1/2\x30\1/2\ index). When materials are used to attach the hang tags to appliance products, the materials shall be of sufficient strength to insure that if gradual pressure is applied to the hang tag by pulling it away from where it is affixed to the product, the hang tag will tear before the material used to affix the hang tag to the product breaks.
(e) Placement--(1) Adhesive labels. Manufacturers shall affix adhesive labels to the covered products in such a position that it is easily read by a consumer examining the product. The label should be generally located on the upper-right-front corner of the product's front exterior. However, some other prominent location may be used as long as the label will not become dislodged during normal handling throughout the chain of distribution to the retailer or consumer. The top of the label should not exceed 74 inches from the base of taller products. The label can be displayed in the form of a flap tag adhered to the top of the appliance and bent (folded at 90[deg]) to hang over the front, as long as this can be done with assurance that it will be readily visible.
(1) Adhesive labels. Manufacturers shall affix adhesive labels to the covered products in such a position that it is easily read by a consumer examining the product. The label should be generally located on the upper-right-front corner of the product's front exterior. However, some other prominent location may be used as long as the label will not become dislodged during normal handling throughout the chain of distribution to the retailer or consumer. The top of the label should not exceed 74 inches from the base of taller products. The label can be displayed in the form of a flap tag adhered to the top of the appliance and bent (folded at 90[deg]) to hang over the front, as long as this can be done with assurance that it will be readily visible.
(2) Hang tags. A hang tag shall be affixed to the interior of the product in such a position that it can be easily read by a consumer examining the product. A hang tag can be affixed in any position that meets this requirement as long as the label will not become dislodged during normal handling throughout the chain of distribution to the retailer or consumer.
(f) Label content. (1) Headlines and texts, as illustrated in the prototype and sample labels in appendix L to this part.
(1) Headlines and texts, as illustrated in the prototype and sample labels in appendix L to this part.
(2) Name of manufacturer or private labeler shall, in the case of a corporation, be deemed to be satisfied only by the actual corporate name, which may be preceded or followed by the name of the particular division of the corporation. In the case of an individual, partnership, or association, the name under which the business is conducted shall be used. Inclusion of the name of the manufacturer or private labeler is optional at the discretion of the manufacturer or private labeler.
(3) Model number(s) will be the designation given by the manufacturer or private labeler.
(4) Capacity or size is that determined in accordance with Sec. 305.7. For refrigerators, refrigerator-freezers, and freezers, the capacity provided on the label shall be the model's total refrigerated volume (VT) as determined in accordance Sec. 305.7.
(5) Unless otherwise indicated in this paragraph, estimated annual operating costs for refrigerators, refrigerator-freezers, freezers, clothes washers, dishwashers, room air conditioners, and water heaters are as determined in accordance with Sec. Sec. 305.5 and 305.10 of this part. Thermal efficiencies for pool heaters are as determined in accordance with Sec. 305.5. Labels for clothes washers and dishwashers must disclose estimated annual operating cost for both electricity and natural gas as illustrated in the sample labels in appendix L. For refrigerators, refrigerator freezers, and freezers manufactured before September 15, 2014, and clothes washers manufactured before March 7, 2015, annual operating costs shall be determined using the energy cost figures of 10.65 cents for electricity and $1.218 for natural gas.
(6) Unless otherwise indicated in this paragraph, ranges of comparability for estimated annual operating costs or thermal efficiencies, as applicable, are found in the appropriate appendices accompanying this part. For refrigerators, refrigerator-freezers, and freezers manufactured on or after September 15, 2014, and clothes washers manufactured on or after March 7, 2015, the range information shall match the text and graphics in sample labels 1A and 2A of Appendix L.
(7) Placement of the labeled product on the scale shall be proportionate to the lowest and highest estimated annual operating costs or thermal efficiencies, as applicable.
(8) Labels for refrigerators, refrigerator-freezers, freezers, dishwashers, clothes washers, and water heaters must contain the model's estimated annual energy consumption as determined in accordance with Sec. 305.5 and as indicated on the sample labels in appendix L. Labels for room air conditioners and pool heaters must contain the model's energy efficiency rating or thermal efficiency, as applicable, as determined in accordance with Sec. 305.5 and as indicated on the sample labels in appendix L.
(9) Labels must contain a statement as illustrated in the prototype labels in appendix L and specified as follows by product type:
(i) For refrigerators, refrigerator-freezers, and freezers, the statement will read as follows (fill in the blanks with the appropriate year and energy cost figures):
Your costs will depend on your utility rates and use.
[Insert statement required by Sec. 305.11(f)(9)(iii)].
Estimated energy cost is based on a national average electricity cost of ---- cents per kWh.
For more information, visit www.ftc.gov/energy.
(ii) For refrigerators, refrigerator-freezers, and freezers manufactured on or after September 15, 2014 and clothes washers manufactured after March 7, 2015, the label shall contain the text and graphics illustrated in sample labels 1A and 2A of Appendix L, including the statement:
Compare ONLY to other labels with yellow numbers.
Labels with yellow numbers are based on the same test procedures.
(iii) For refrigerators, refrigerator-freezers, and freezers, the following sentence shall be included as part of the statement required by Sec. 305.11(f)(9)(i):
(A) For models covered under appendix A1, the sentence shall read:
Cost range based only on models of similar capacity with automatic defrost.
(B) For models covered under appendix A2, the sentence shall read:
Cost range based only on models of similar capacity with manual defrost.
(C) For models covered under appendix A3, the sentence shall read:
Cost range based only on models of similar capacity with partial automatic defrost.
(D) For models covered under appendix A4, the sentence shall read:
Cost range based only on models of similar capacity with automatic defrost, top-mounted freezer, and without through-the-door ice.
(E) For models covered under appendix A5, the sentence shall read:
Cost range based only on models of similar capacity with automatic defrost, side-mounted freezer, and without through-the-door ice.
(F) For models covered under appendix A6, the sentence shall read:
Cost range based only on models of similar capacity with automatic defrost, bottom-mounted freezer, and without through-the-door ice.
(G) For models covered under appendix A7, the sentence shall read:
Cost range based only on models of similar capacity with automatic defrost, top-mounted freezer, and through-the-door ice.
(H) For models covered under appendix A8, the sentence shall read:
Cost range based only on models of similar capacity with automatic defrost, side-mounted freezer, and through-the-door ice.
(I) For models covered under appendix B1, the sentence shall read:
Cost range based only on upright freezer models of similar capacity with manual defrost.
(J) For models covered under appendix B2, the sentence shall read:
Cost range based only on upright freezer models of similar capacity with automatic defrost.
(K) For models covered under appendix B3, the sentence shall read:
Cost range based only on chest and other freezer models of similar capacity.
(iv) For room air conditioners covered under appendix E, the statement will read as follows (fill in the blanks with the appropriate model type, year, energy type, and energy cost figure):
Your costs will depend on your utility rates and use.
Cost range based only on models [of similar capacity without reverse cycle and with louvered sides; of similar capacity without reverse cycle and without louvered sides; with reverse cycle and with louvered sides; or with reverse cycle and without louvered sides].
Estimated annual energy cost is based on a national average electricity cost of ---- cents per kWh and a seasonal use of 8 hours use per day over a 3 month period.
For more information, visit www.ftc.gov/energy.
(v) For water heaters covered by Appendices D1, D2, and D3, the statement will read as follows (fill in the blanks with the appropriate fuel type, year, and energy cost figures):
Your costs will depend on your utility rates and use.
Cost range based only on models of similar capacity fueled by [natural gas, oil, propane, or electricity].
Estimated energy cost is based on a national average [electricity, natural gas, propane, or oil] cost of [---- cents per kWh or $---- per therm or gallon].
For more information, visit www.ftc.gov/energy.
(vi) For instantaneous water heaters (appendix D4) and heat pump water heaters (appendix D5), the statement will read as follows (fill in the blanks with the appropriate model type, the operating cost, the year, and the energy cost figures):
Your costs will depend on your utility rates and use.
Cost range based only on [instantaneous gas water heater or heat pump water heater] models of similar capacity. Estimated energy cost is based on a national average [electricity, natural gas, or propane] cost of [---- cents per kWh or $---- per therm or gallon].
For more information, visit www.ftc.gov/energy.
(vii) For dishwashers covered by appendices C1 and C2, the statement will read as follows (fill in the blanks with the appropriate appliance type, the energy cost, the number of loads per week, the year, and the energy cost figures):
Your costs will depend on your utility rates and use.
Cost range based only on [compact/standard] capacity models.
Estimated energy cost is based on 4 washloads a week, and a national average electricity cost of ---- cents per kWh and natural gas cost of $---- per therm.
For more information, visit www.ftc.gov/energy.
(viii) For clothes washers manufactured before March 7, 2015 covered by appendices F1 and F2, the statement will read as follows (fill in the blanks with the appropriate appliance type, the energy cost, the number of loads per week, the year, and the energy cost figures):
Your costs will depend on your utility rates and use.
Cost range based only on [compact/standard] capacity models.
Estimated energy cost is based on 8 washloads a week and a national average electricity cost of ---- cents per kWh and natural gas cost of $---- per therm.
For more information, visit www.ftc.gov/energy.
(ix) For clothes washers manufactured after March 7, 2015, the label shall contain the text and graphics illustrated in sample labels 1A and 2A of Appendix L, including the statement:
Compare ONLY to other labels with yellow numbers.
Labels with yellow numbers are based on the same test procedures.
(x) For pool heaters covered under appendices J1 and J2, the statement will read as follows:
Efficiency range based only on models fueled by [natural gas or oil].
For more information, visit www.ftc.gov/energy.
(10) The following statement shall appear on each label as illustrated in the prototype and sample labels in appendix L:
Federal law prohibits removal of this label before consumer purchase.
(11) No marks or information other than that specified in this part shall appear on or directly adjoining this label except that:
(i) A part or publication number identification may be included on this label, as desired by the manufacturer. If a manufacturer elects to use a part or publication number, it must appear in the lower right-hand corner of the label and be set in 6-point type or smaller.
(ii) The energy use disclosure labels required by the governments of Canada or Mexico may appear directly adjoining this label, as desired by the manufacturer.
(iii) The manufacturer or private labeler may include the ENERGY STAR logo on the bottom right corner of the label for certified products. The logo must be 1 inch by 1 inch in size. Only manufacturers that have signed a Memorandum of Understanding with the Department of Energy or the Environmental Protection Agency may add the ENERGY STAR logo to labels on certified covered products; such manufacturers may add the ENERGY STAR logo to labels only on those covered products that are contemplated by the Memorandum of Understanding. [72 FR 49967, Aug. 29, 2007, as amended at 78 FR 2208, Jan. 10, 2013; 78 FR 43981, July 23, 2013]