Code of Federal Regulations (alpha)

CFR /  Title 30  /  Part 46  /  Sec. 46.6 Newly hired experienced miner training.

(a) Except as provided in paragraph (f) of this section, you must provide each newly hired experienced miner with training as prescribed by paragraphs (b) and (c). ----------------------------------------------------------------------------------------------------------------

----------------------------------------------------------------------------------------------------------------(b) Before a newly hired experienced miner begins work at the You must provide the miner with training in the

mine-- following subjects, which must also address

site-specific hazards:

(1) An introduction to the work environment,

including a visit and tour of the mine, or

portions of the mine that are representative

of the entire mine (walkaround training). The

method of mining or operation utilized must be

explained and observed;

(2) Instruction on the recognition and

avoidance of electrical hazards and other

hazards present at the mine, such as traffic

patterns and control, mobile equipment (e.g.,

haul trucks and front-end loaders), and loose

or unstable ground conditions;

(3) A review of the emergency medical

procedures, escape and emergency evacuation

plans, in effect at the mine, and instruction

on the firewarning signals and firefighting

procedures;

(4) Instruction on the health and safety

aspects of the tasks to be assigned, including

the safe work procedures of such tasks, the

mandatory health and safety standards

pertinent to such tasks, information about the

physical and health hazards of chemicals in

the miner's work area, the protective measures

a miner can take against these hazards, and

the contents of the mine's HazCom program;

(5) Instruction on the statutory rights of

miners and their representatives under the

Act;

(6) A review and description of the line of

authority of supervisors and miners'

representatives and the responsibilities of

such supervisors and miners' representatives;

and

(7) An introduction to your rules and

procedures for reporting hazards.----------------------------------------------------------------------------------------------------------------(c) No later than 60 calendar days after a newly hired You must provide the miner with an instruction

experienced miner begins work at the mine-- and demonstration on the use, care, and

maintenance of self-rescue and respiratory

devices, if used at the mine.----------------------------------------------------------------------------------------------------------------

(d) Practice under the close observation of a competent person may be used to fulfill the requirement for training on the health and safety aspects of an assigned task in paragraph (b)(4) of this section, if hazard recognition training specific to the assigned task is given before the miner performs the task.

(e) In addition to subjects specified in paragraphs (b) and (c) of this section, you may provide training on any other subjects that promote occupational health and safety for miners.

(f) You are not required to provide a newly hired experienced miner who returns to the same mine, following an absence of 12 months or less, with the training specified in paragraphs (b) and (c) of this section. Instead you must provide such miner with training on any changes at the mine that occurred during the miner's absence that could adversely affect the miner's health or safety. This training must be given before the miner begins work at the mine. If the miner missed any part of annual refresher training under Sec. 46.8 of this part during the absence, you must provide the miner with the missed training no later than 90 calendar days after the miner begins work at the mine. [64 FR 53130, Sept. 30, 1999, as amended at 67 FR 42382, June 21, 2002]