(a) You must comply with all of the recordkeeping and reporting requirements specified in Sec. 63.10 that are referenced in Table 1 to this subpart.
(1) Records must be maintained in a form suitable and readily available for expeditious review, according to Sec. 63.10(b)(1). However, electronic recordkeeping and reporting if suitable for the specific case (e.g., by electronic media such as Excel spreadsheet, on CD or hard copy), and when required by this subpart.
(2) Records must be kept on site for at least 2 years after the date of occurrence, measurement, maintenance, corrective action, report, or record, according to Sec. 63.10(b)(1).
(b) The standard operating procedures manuals required in Secs. 63.545(a) and 63.548(a) must be submitted to the Administrator in electronic format for review and approval of the initial submittal and whenever an update is made to the procedure.
(c) You must maintain for a period of 5 years, records of the information listed in paragraphs (c)(1) through (13) of this section.
(1) Electronic records of the bag leak detection system output.
(2) An identification of the date and time of all bag leak detection system alarms, the time that procedures to determine the cause of the alarm were initiated, the cause of the alarm, an explanation of the corrective actions taken, and the date and time the cause of the alarm was corrected.
(3) All records of inspections and maintenance activities required under Sec. 63.548(c) as part of the practices described in the standard operating procedures manual for baghouses required under Sec. 63.548(a).
(4) Electronic records of the pressure drop and water flow rate values for wet scrubbers used to control metal hazardous air pollutant emissions from process fugitive sources as required in Sec. 63.548(i).
(5) Electronic records of the output from the continuous temperature monitor required in Sec. 63.548(j)(1), and an identification of periods when the 3-hour average temperature fell below the minimum established under Sec. 63.548(j)(4), and an explanation of the corrective actions taken.
(6) Electronic records of the continuous pressure monitors for total enclosures required in Sec. 63.548(k), and an identification of periods when the pressure was not maintained as required in Sec. 63.544(c)(1).
(7) Records of any time periods power was lost to the continuous pressure monitors for total enclosures required in Sec. 63.548(k) and records of loss of power to the air handling system maintaining negative pressure on total enclosures.
(8) Records of the inspections of facility enclosures required in Sec. 63.544(d).
(9) Records of all cleaning and inspections required as part of the practices described in the standard operating procedures manual required under Sec. 63.545(a) for the control of fugitive dust emissions.
(10) Electronic records of the output of any CEMS installed to monitor lead emissions meeting the requirements of Sec. 63.548(m).
(11) Records of the occurrence and duration of each malfunction of operation (i.e., process equipment) or the air pollution control equipment and monitoring equipment.
(12) Records of actions taken during periods of malfunction to minimize emissions in accordance with Sec. 63.543(k), including corrective actions to restore malfunctioning process and air pollution control and monitoring equipment to its normal or usual manner of operation.
(13) Records of any periods of startup or shutdown of a furnace and actions taken to minimize emissions during that period in accordance with Sec. 63.543(l).
(d) You must comply with all of the reporting requirements specified in Sec. 63.10 of the General Provisions that are referenced in Table 1 to this subpart.
(1) You must submit reports no less frequent than specified under Sec. 63.10(e)(3) of the General Provisions.
(2) Once a source reports a violation of the standard or excess emissions, you must follow the reporting format required under Sec. 63.10(e)(3) until a request to reduce reporting frequency is approved by the Administrator.
(e) In addition to the information required under the applicable sections of Sec. 63.10, you must include in the reports required under paragraph (d) of this section the information specified in paragraphs (e)(1) through (14) of this section.
(1) Records of the concentration of lead in each process vent, and records of the rolling 12-month flow-weighted average concentration of lead compounds in vent gases calculated monthly as required in Sec. 63.543(a), except during the first year when the concentration is calculated using the method described in Sec. 63.543(a)(2).
(2) Records of the concentration of total hydrocarbon and dioxins and furans in each process vent that has established limits for total hydrocarbon and dioxins and furans as required in Sec. 63.543(c).
(3) Records of all periods when monitoring using a CEMS for lead or total hydrocarbon was not in compliance with applicable limits.
(4) Records of all alarms from the bag leak detection system specified in Sec. 63.548.
(5) A description of the procedures taken following each bag leak detection system alarm pursuant to Sec. 63.548(f)(1) and (2).
(6) A summary of the records maintained as part of the practices described in the standard operating procedures manual for baghouses required under Sec. 63.548(a), including an explanation of the periods when the procedures were not followed and the corrective actions taken.
(7) An identification of the periods when the pressure drop and water flow rate of wet scrubbers used to control process fugitive sources dropped below the levels established in Sec. 63.548(i), and an explanation of the corrective actions taken.
(8) Records of the temperature monitor output, in 3-hour block averages, for those periods when the temperature monitored pursuant to Sec. 63.548(j) fell below the level established in Sec. 63.548(j)(4).
(9) Certification that the plastic separation process for battery breakers required in Sec. 63.543(m) was operated at all times the battery breaker was in service.
(10) Records of 15-minute periods when the pressure was not maintained as required in Sec. 63.544(c) or power was lost to the continuous pressure monitoring system as required in Sec. 63.548(k). Records of which wall is chosen as the windward wall must be included in the records required by Sec. 63.10(c) if a total enclosure located within a larger structure is not impacted by ambient wind.
(11) If a malfunction occurred during the reporting period, the report must include the number, duration, and a brief description for each type of malfunction that occurred during the reporting period and caused or may have caused any applicable emissions limitation to be exceeded. The report must also include a description of actions taken during a malfunction of an affected source to minimize emissions in accordance with Sec. 63.543(k), including actions taken to correct a malfunction.
(12) A summary of the fugitive dust control measures performed during the required reporting period, including an explanation of the periods when the procedures outlined in the standard operating procedures manual pursuant to Sec. 63.545(a) were not followed and the corrective actions taken. The reports must not contain copies of the daily records required to demonstrate compliance with the requirements of the standard operating procedures manuals required under Sec. 63.545(a).
(13) Records of any periods of startup or shutdown of a furnace including an explanation of the periods when the procedures required in Sec. 63.543(l) were not followed and the corrective actions taken.
(14) You must submit records pursuant to paragraphs (e)(14)(i) through (iii) of this section.
(i) As of January 1, 2012 and within 60 days after the date of completing each performance test, as defined in Sec. 63.2 and as required in this subpart, you must submit performance test data, except opacity data, electronically to EPA's Central Data Exchange by using the Electronic Reporting Tool (see http://www.epa.gov/ttn/chief/ert/ert--tool.html/). Only data collected using test methods compatible with the Electronic Reporting Tool are subject to this requirement to be submitted electronically into EPA's WebFIRE database.
(ii) Within 60 days after the date of completing each CEMS performance evaluation test, as defined in Sec. 63.2 and required by this subpart, you must submit the relative accuracy test audit data electronically into EPA's Central Data Exchange by using the Electronic Reporting Tool as mentioned in paragraph (e)(14)(i) of this section. Only data collected using test methods compatible with the Electronic Reporting Tool are subject to this requirement to be submitted electronically into EPA's WebFIRE database.
(iii) All reports required by this subpart not subject to the requirements in paragraph (e)(14)(i) and (ii) of this section must be sent to the Administrator at the appropriate address listed in Sec. 63.13. The Administrator or the delegated authority may request a report in any form suitable for the specific case (e.g., by electronic media such as Excel spreadsheet, on CD or hard copy). The Administrator retains the right to require submittal of reports subject to paragraph (e)(14)(i) and (ii) of this section in paper format. [77 FR 580, Jan. 5, 2012, as amended at 79 FR 372, Jan. 3, 2014]