(a) Chemical substance and significant new uses subject to reporting. (1) The chemical substance identified generically as multi-walled carbon nanotubes (PMN P-10-246) is subject to reporting under this section for the significant new uses described in paragraph (a)(2) of this section. The requirements of this rule do not apply to quantities of the PMN substance after it has been completely reacted (cured); embedded or incorporated into a polymer matrix that itself has been reacted (cured); embedded in a permanent solid polymer form that is not intended to undergo further processing, except for mechanical processing.
(1) The chemical substance identified generically as multi-walled carbon nanotubes (PMN P-10-246) is subject to reporting under this section for the significant new uses described in paragraph (a)(2) of this section. The requirements of this rule do not apply to quantities of the PMN substance after it has been completely reacted (cured); embedded or incorporated into a polymer matrix that itself has been reacted (cured); embedded in a permanent solid polymer form that is not intended to undergo further processing, except for mechanical processing.
(2) The significant new uses are:
(i) Protection in the workplace. Requirements as specified in Sec. 721.63(a)(1), (a)(2)(i), (a)(2)(ii), (a)(3), (a)(4), (a)(6)(i), (a)(6)(ii), and (c). When determining which persons are reasonably likely to be exposed as required for Sec. 721.63(a)(1) and (a)(4), engineering control measures (e.g., physical containment, exhaust control ventilation, or isolation) or administrative control measures (e.g., workplace policies and procedures) shall be considered and implemented to prevent exposure, where feasible. The following National Institute for Occupational Safety and Health (NIOSH)-certified respirators with an assigned protection factor (APF) of at least 50 meet the minimum requirements for Sec. 721.63(a)(4):
(A) NIOSH-certified air-purifying, tight-fitting full-face respirator equipped with N100 (if oil aerosols absent), R100, or P100 filters;
(B) NIOSH-certified powered air-purifying respirator equipped with a loose-fitting hood or helmet and high efficiency particulate air (HEPA) filters; or
(C) NIOSH-certified powered air-purifying respirator equipped with a tight-fitting facepiece (either half-face or full-face) and HEPA filters.
(ii) Industrial, commercial, and consumer activities. Requirements as specified in Sec. 721.80(f), (k) (conductivity additive to resins, rubber, and to battery electrodes), and (q).
(iii) Release to water. Requirements as specified in Sec. 721.90(b)(1), and (c)(1).
(b) Specific requirements. The provisions of subpart A of this part apply to this section except as modified by this paragraph.
(1) Recordkeeping. Recordkeeping requirements as specified in Sec. 721.125(a), (b), (c), (d), (e), (i), and (k) are applicable to manufacturers, and processors of this substance.
(2) Limitations or revocation of certain notification requirements. The provisions of Sec. 721.185 apply to this section.
(3) Determining whether a specific use is subject to this section. The provisions of Sec. 721.1725(b)(1) apply to paragraph (a)(2)(ii) of this section. [78 FR 38222, June 26, 2013]